Save Brother PR-1000 Jumbo Frame Design

Embird Embroidery Software Tutorial

1 - Run Embird and click the "Editor" menu to switch to the Editor window.

2 - Open the design that you want to save for the Brother PR-1000 Jumbo Frame. To open a design, click the "File" menu and choose the "Open" command. Please note that you will probably have to split this design into two parts.

3 - Click the "Hoop Size" button, or select the "Options > Hoop Size" menu (Picture No. 1).

1. Select the "Options > Hoop Size" menu

4 - Choose the "Brother PR-1000 Jumbo Frame - Horizontal" or "Vertical" option (Picture No. 2). Typical orientation is horizontal, with two overlapping sections. The vertical position works the same way as the horizontal does; the parts are simply automatically rotated by -90 degrees when loading/saving from/to the hard disk. Confirm the hoop selection by clicking the "OK" button.

2. Choose the right hoop

5 - You can see now that the design exceeds the size of one of the two overlapping sections (red, green). Notice the red rectangle drawn around the design icon at the right side of the screen - it indicates that the object is out of the section. Therefore, the design must be split into two parts (Picture No. 3). Use the "Freehand Select Mode" button to select the stitches you want to cut out (separate). More information regarding splitting is available in the Interactive Freehand Splitting tutorial.

Note: It is possible to skip the following steps and continue to step 8. Embird can automatically split the design in such a way that each object fits a section. However, sometimes it is better to split the design manually to obtain an optimal result.

3. Notice hoop sections

6 - Once you have selected the area you want to separate, it will be displayed in red. Click the "Split" button (or select the "Edit > Split" menu) to split the design; this will separate the red selection (Picture No. 4).

4. Split design

7 - You can see the design parts (1 and 2) in the "Object Order Bar" at the right side of the screen (Picture No. 5). Each part now lies completely either in the top (red) or in the bottom (green) section of the hoop; therefore, there is no red rectangle around any object.

5. Design parts fit hoop sections

8 - Use the "File > Save As" command to save the whole design to a file on your disk. In the "Choose Format" dialog box, choose the Babylock, Bernina, Brother .PES format. In the second dialog box that appears on the screen, you can choose the file name of the design being saved. Embird will save both parts (i.e., both hoop sections) into a single .PES file.

Back to Embird Tutorial Contents